+# get installed and where they finally will reside. As of 5.005_6x,
+# this too is handled automatically by Configure based on
+# $installprefix, so it isn't included here either.
+#
+# Note also that there are three broad hierarchies of installation
+# directories, as discussed in the INSTALL file under
+# "Installation Directories":
+#
+# =item Directories for the perl distribution
+#
+# =item Directories for site-specific add-on files
+#
+# =item Directories for vendor-supplied add-on files
+#
+# See Porting/Glossary for the definitions of these names, and see the
+# INSTALL file for further explanation and some examples.
+#
+# In each case, if your previous value was the default, leave it commented
+# out. That way, if you override prefix, all of these will be
+# automatically adjusted.
+#
+# WARNING: Be especially careful about architecture-dependent and
+# version-dependent names, particularly if you reuse this file for
+# different versions of perl.
+
+!GROK!THIS!
+
+# Set the following variables. Mention them here so metaconfig
+# includes the appropriate code in Configure
+# $bin $scriptdir $privlib $archlib
+# $man1dir $man3dir $html1dir $html3dir
+# $sitebin $sitescript $sitelib $sitearch
+# $siteman1dir $siteman3dir $sitehtml1dir $sitehtml3dir
+# $vendorbin $vendorscript $vendorlib $vendorarch
+# $vendorman1dir $vendorman3dir $vendorhtml1dir $vendorhtml3dir
+
+for var in \
+ bin scriptdir privlib archlib man1dir man3dir man1ext man3ext \
+ html1dir html3dir \
+ sitebin sitescript sitelib sitearch \
+ siteman1dir siteman3dir sitehtml1dir sitehtml3dir \
+ vendorbin vendorscript vendorlib vendorarch \
+ vendorman1dir vendorman3dir vendorhtml1dir vendorhtml3dir
+do
+
+ case "$var" in