perldiag: Move the \p{} entry

[perl5.git] / README.netware

diff --git a/README.netware b/README.netware
index 1e92b84..c83fc94 100644 (file)
--- a/README.netware
+++ b/README.netware
@@ -48,14 +48,25 @@ sets the build type to Release by default.
 This is used to set the build type to debug or release. Change the
 build type only after executing SetNWBld.bat
 
-=item *
-
 Example:
-  1. Typing "buildtype d on" at the command prompt causes the buildtype
-     to be set to Debug type with D2 flag set. 
-  2. Typing "buildtype d off" or "buildtype d" at the command prompt causes
-     the buildtype to be set to Debug type with D1 flag set. 
-  2. Typing "buildtype r" at the command prompt sets it to Release Build type.
+
+=over
+
+=item 1.
+
+Typing "buildtype d on" at the command prompt causes the buildtype
+to be set to Debug type with D2 flag set. 
+
+=item 2.
+
+Typing "buildtype d off" or "buildtype d" at the command prompt causes
+the buildtype to be set to Debug type with D1 flag set. 
+
+=item 3.
+
+Typing "buildtype r" at the command prompt sets it to Release Build type.
+
+=back
 
 =back
 
@@ -64,7 +75,7 @@ Example:
 The make process runs only under WinNT shell.  The NetWare makefile is
 located under the NetWare folder.  This makes use of miniperl.exe to
 run some of the Perl scripts. To create miniperl.exe, first set the
-required paths for Visual c++ compilier (specify vcvars32 location) at
+required paths for Visual c++ compiler (specify vcvars32 location) at
 the command prompt.  Then run nmake from win32 folder through WinNT
 command prompt.  The build process can be stopped after miniperl.exe
 is created. Then run nmake from NetWare folder through WinNT command